Drying

best practices

Put Your Dryers on a Preventive Maintenance Program

No one likes to do them. Many avoid them altogether. But a periodic “PM” program for your dryers pays off in the long run.

Read More
monitoring

AUXILIARY EQUIPMENT: System-Wide PLC Control of AuxilIaries

New control system priced below older technologies.

Read More

Optimized Molding Is Possible With Material Drying, Handling

Injection speed and overall cycle time are often the focus for molders pursuing optimized processes, but for truly efficient production, molders should consider how and in what state material arrives at the machine.

Read More
Drying

New System Measures Moisture In Pellets During Processing

Self-calibrating system measures pellet moisture in real time and can adjust dryer controls accordingly.

Read More
Postindustrial

Why & When Should You Re-Crystallize PET Scrap?

Whether you’re blow molding PET bottles or extruding APET sheet, you’ll produce amorphous scrap in the process. How you handle it will impact your production costs. Re-crystallizing it will help.

Read More
Drying

‘Wearable’ Machine Sensors Extended to Power Factor & Retrofits

As is often the case with a new technology, customers are dictating how predictive-maintenance sensors will be applied and where they might be headed next.

Read More
Drying

Measure Pellet Moisture Online: A Second System Debuts at Fakuma

Moretto will show a system to measure pellet moisture minute-by-minute and automatically adjust the dryer, if necessary.

Read More
Sheet Extrusion

How to Keep Moisture Away From Your APET Sheet Line

Moisture in PET will result in degradation that will foul up sheet and thermoformed products. Keep it at bay by following these tips when drying APET virgin and flake material.

Read More

Auxiliaries AT NPE: New Controls Link Auxiliaries

Industry 4.0—the internet of things—is bringing a new level of connectivity to auxiliary equipment. Here’s a rundown of developments there, along with other news in auxiliaries from the show.

Read More

Milan Plast Was Good With Plans To Be Even Better

Big international turnout at the triennial international fair for the plastics and rubber industry, Milan Plast: check out the Plastics Technology slideshow.

Read More
chemical foaming agents for molding and extrusion
New 2024 Twin Screw Report
Thinswitch confirms ejector plate return
Glycon's DM2: The High Performance Feedscrew
Stop Wasting. Start Shredding
Resinworks with Optimizer
Register Now!
Purgex: Made in the USA. Trusted Globally.
Elevate your PET sorting