In-Mold Decorating
Formable Luminescent Films Can Be Backmolded
Polycarbonate electroluminescent films can provide light in homes, cars, cellphones, and even inside ladies’ handbags.
Read More
K 2007 Injection Molding: Lots of New Machine Choices For Exotic to Everyday Molding
If you were looking for a new machine to mold micro- or mega-sized parts, multiple materials, long fibers, high-speed/high-cavitation packaging, exotic multi-material combinations with compounding on the machine, or just a cost-effective press for general-purpose use—K 2007 had it all.
Read More
Auto Glazing: Film, Coinjection & Coating Technologies Advance
Hard-surfacing options for molded plastic glazing now include plasma instead of wet coatings–and replacing coatings altogether with in-mold film lamination or multi-layer coinjection.
Read More
What's New at the Show in INJECTION MOLDING
At the big “K” Show next month, top billing goes to new all-electric machines aimed at every segment of the market, from general-purpose to high-end.
Read More
Dual-Cure PUR Coatings Boost Performance Of In-Mold Decorating Films
A new version of in-mold decorating technology, developed initially for exterior auto body components, uses dual-cure coating technology to provide a paint film that is both stretchable for good thermoformability and also provides the high gloss and durability of conventional paints.
Read More
Thermoforming: Ready for In-Mold Labeling?
After several fits and starts over the last decade, thermoforming IML appears ready for prime time, thanks to improvements in output and labeling technology. For now, the action is mostly in European packaging.
Read More
In-Mold Assembly: The New Frontier for Multi-Shot Molding
The drive to eliminate secondary operations is pushing multi-shot injection molding a step farther—toward assembling separate components in the tool via snap-fits, welding, and co-molding of incompatible materials.
Read More
Rigid Packaging Goes Lighter, Thinner With Microcellular Foam
Molding higher volumes of a rigid thin-wall part typically means going to a larger press for increased injection and clamping capacity.
Read More
Learning to Master In-Mold Labeling
As in-mold labeling, or IML, attracts a growing following among U.S. molders, some are finding that mastering a complex new technology is no small task.
Read MoreThermoformer Offers Help With IMD
Hy-tech Forming Systems (USA) Inc., Phoenix, Ariz., is a specialist in close-tolerance forming of printed film using hydroforming, a technology utilizing fluid pressure behind a diaphragm to force heated film into a mold.
Read More
