Timothy Womer Founder
Contact
Injection Molding Virgin vs. Regrind
Most processing operations generate regrind. Therefore, it is necessary to be able to reprocess the regrind back into the part.
Read MoreSome Helpful Hints on Grooved-Feed Extruders
There are a few things that are different between these and their smooth-bore cousins that processors should know.
Read MoreScrews and Screen Changers
There are precautions that need to be taken when adding a screen changer.
Read MoreEngraved Rolls
On engraved or textured rolls, ensure the outer shell is made from a seamless tube.
Read MoreScrew Speed vs. Recovery Time
Many times the screw speed is not setup to operate at its most effective operation.
Read MoreProper Shut-down and Start-up Methods
You might have your own approach, but by following these procedures you'll likely get the best results.
Read MoreAuditing Your Extruder
From time to time it is necessary to do a complete audit on the condition of an extruder to make sure that it is operating in top condition for maximum effectiveness and efficiency.
Read MoreSolving Poor Solids Conveying
Molders quite often call me and say their screw is “windmilling” or “isn’t picking up the material.” This phenomena is due to poor solids conveying.
Read More
Why—and How—to Baseline Your Extruder
If you don’t baseline your extruder, then how are you going to set realistic expectations for its performance? Here's how to get going.
Read More
